DTC P0116 Engine Coolant Temperature Circuit Range / Performance Problem |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0116 | When either of following conditions met (2 trip detection logic):
|
|
| P0116 | For Mexico Models: Case 1: Engine Coolant Temperature (ECT) between 35°C and 60°C (95°F and 140°F) when engine started, and conditions (a) and (b) met (2 trip detection logic) (a) Vehicle driven at varying speeds (accelerated and decelerated) (b) ECT remains within 3°C (5.4°F) of initial ECT Case 2: ECT more than 60°C (140°F) when engine started, and conditions (a) and (b) met (6 trip detection logic) (a) Vehicle driven at varying speeds (accelerated and decelerated) (b) ECT measurements remain within 1°C (1.8°F) of initial ECT on 6 successive occasions |
|
| Related DTCs | P0116: Engine coolant temperature (ECT) sensor cold start monitor P0116: ECT sensor soak monitor |
| Required Sensors/Components (Main) | ECT sensor |
| Required Sensors/Components (Related) | None |
| Frequency of Operation | Once per driving cycle |
| Duration | 10 seconds or more |
| MIL Operation | 2 driving cycles |
| Sequence of Operation | None |
| Monitor runs whenever following DTCs not present | P0112, P0113 (Intake air temperature sensor) |
| Battery voltage | 10.5 V or more |
| Time after engine start | 1 second or more |
| ECT at engine start | Less than 60°C (140°F) |
| Soak time | 0 seconds or more |
| Accumulated MAF | 2497 g or more |
| Fuel cut | OFF |
| Difference between ECT at engine start and IAT | Less than 40°C (72°F) |
| Monitor runs whenever following DTCs not present | P0112, P0113 (Intake air temperature sensor) |
| Battery voltage | 10.5 V or more |
| Engine | Running |
| Soak time | 5 hours or more |
| Either (a) or (b) condition met | - |
| (a) ECT | 60°C (140°F) or more |
| (b) Accumulated MAF | 5242 g or more |
| ECT sensor value change | Less than 5°C (9°F) |
| Difference between current ECT sensor value and previous ECT sensor value when engine stopped | Less than 5°C (9°F) [varies with ECT of last trip engine stop] |
| ECT | ECT sensor value changes in accordance with actual ECT |
| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0116) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTC.
| Result | Proceed to |
| P0116 is output | A |
| P0116 and other DTCs are output | B |
|
| ||||
| A | |
| 2.INSPECT THERMOSTAT |
Remove the thermostat (Click here).
Measure the valve opening temperature of the thermostat.
Reinstall the thermostat (Click here).
|
| ||||
| OK | ||
| ||