DTC P0420 Catalyst System Efficiency Below Threshold (Bank 1) |
DTC P0430 Catalyst System Efficiency Below Threshold (Bank 2) |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0420 | OSC value smaller than standard value under active air-fuel ratio control (2 trip detection logic) |
|
| P0430 | OSC value smaller than standard value under active air-fuel ratio control (2 trip detection logic) |
|
| Related DTCs | P0420: Catalyst Deterioration (for Bank 1) P0430: Catalyst Deterioration (for Bank 2) |
| Required Sensors/Components (Main) | A/F sensor and HO2 sensor |
| Required Sensors/Components (Related) | Intake air temperature sensor, mass air flow meter, crankshaft position sensor and engine coolant temperature sensor |
| Frequency of Operation | Once per driving cycle |
| Duration | About 30 seconds |
| MIL Operation | 2 driving cycles |
| Sequence of Operation | None |
| Monitor runs whenever following DTCs not present | P0010, P0020 (VVT Oil Control Valve) P0011, P0021 (VVT System - Advance) P0012, P0022 (VVT System - Retard) P0016, P0018 (VVT System - Misalignment) P0013, P0023 (Exhaust VVT Oil Control Valve) P0014, P0024 (Exhaust VVT System - Advance) P0015, P0025 (Exhaust VVT System - Retard) P0017, P0019 (Exhaust VVT System - Misalignment) P0031, P0032, P0051, P0052 (Air Fuel Ratio Sensor Heater) P0037, P0038, P0057, P0058 (Rear Oxygen Sensor Heater) P2195, P2196, P2197, P2198, P2237, P2238, P2239, P2240, P2241, P2242, P2252, P2253, P2255, P2256, P2A00, P2A03 (Air Fuel Ratio Sensor) P0136, P0137, P0138, P0139, P0156, P0157, P0158, P0159, P0607 (Rear Oxygen Sensor) P0102, P0103 (Mass Air Flow Sensor) P0115, P0117, P0118 (Engine Coolant Temperature Sensor) P0125 (Insufficient Coolant Temperature for Closed Loop Fuel Control) P0120, P0121, P0122, P0123, P0220, P0222, P0223, P2135 (Throttle Position Sensor) P0171, P0172, P0174, P0175 (Fuel System) P0301 - P0308 (Misfire) P0335 (Crankshaft Position Sensor) P1340 (Camshaft Position Sensor) P0340, P0342, P0343, P0345, P0347, P0348 (VVT Sensor) P0365, P0367, P0368, P0390, P0392, P0393 (Exhaust VVT Sensor) P0351 - P0358 (Igniter) P0412, P0415, P0418, P0419, P1613, P1614 (Secondary Air Injection System Control) P2440, P2441, P2442, P2443, P2444, P2445, P2446, P2447 (Secondary Air Injection System) P0500 (Vehicle Speed Sensor) |
| Battery voltage | 11 V or more |
| Intake air temperature | -10°C (14°F) or more |
| Engine coolant temperature | 75°C (167°F) or more |
| Atmospheric pressure | 76 kPa (570 mmHg) or more |
| Idling | OFF |
| Engine speed | Less than 3200 rpm |
| A/F sensor status | Activated |
| Fuel system status | Closed loop |
| Engine load | 10 to 75% |
| All of following conditions (a), (b) and (c) met | - |
| (a) Mass air flow rate | 7.5 to 75 g/sec. |
| (b) Estimated front catalyst temperature | 575 to 820°C (1067 to 1508°F) |
| (c) Estimated rear catalyst temperature | 400 to 700°C (752 to 1292°F) |
| Rear HO2 sensor heater monitor | Completed |
| Transmission gear | 4th or higher |
| Oxygen Storage Capacity (OSC) of Three-Way Catalytic Converter (TWC) | Less than 0.12 g |



| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0420 OR P0430) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read DTCs.
| Result | Proceed to |
| P0420 or P0430 is output | A |
| P0420 or P0430 and other DTCs are output | B |
|
| ||||
| A | |
| 2.CHECK SENSOR OUTPUT |
Warm up the engine until the engine coolant temperature is 75°C (167°F) or more.
Connect the Techstream to the DLC3.
Stop the engine.
Turn the ignition switch to ON.
Turn the Techstream on.
Write down the freeze frame data.
Clear the DTCs (Click here).
Enter the following menus: Powertrain / Engine and ECT / Data List / Flexible Fuel Vehicle.
Record data using snapshots.
Start the engine.
Drive the vehicle at 32 km/h (20 mph) or more and maintain a constant speed for 2 minutes or more.
After this driving make sure that the Data List "Alcohol Density Learning" is "Compl".
Monitor the output voltages of the A/F and HO2 sensors (AFS Voltage B1S1 and O2S B1S2 or AFS Voltage B2S1 and O2S B2S2) displayed on the Techstream.
| Result | Proceed to |
| A/F sensor and O2 sensor output both consistently indicate rich or lean or Aggregate fuel trim*1 less than -20% or Aggregate fuel trim*1 more than 65% | A |
| A/F sensor output consistently outside range of 3.1 to 3.4 V and O2 sensor output and A/F sensor output contradict each other*2 | B |
| A/F sensor output between 3.1 and 3.4 V and O2 sensor output consistently indicates rich or lean | C |
| A/F sensor output between 3.1 and 3.4 V and O2 sensor output slowly changes in the range of 0 and 1 V and Aggregate fuel trim*1 between -20 and 65% | D |
| Air-fuel Ratio | A/F Sensor | HO2 Sensor |
| Lean | Higher than 3.25 V | Below 0.4 V |
| Rich | Below 3.25 V | Higher than 0.55 V |
| AFS Voltage B1 S1 | 3.28 V |
| AFS Voltage B2 S1 | 3.28 V |
| O2S B1 S2 | 0.76 V |
| O2S B2 S2 | 0.70 V |
| Short FT #1 | 1% |
| Long FT #1 | -6% |
| Short FT #2 | 2% |
| Long FT #2 | -6% |
| AF Lambda B1 S1 | 0.99 |
| AF Lambda B2 S1 | 0.99 |
| Alcohol Density Estimate | 0% |
| Alcohol Density Learning | Compl |
| AFS Voltage B1 S1 | 4.99 V |
| AFS Voltage B2 S1 | 3.25 V |
| O2S B1 S2 | 0.95 V |
| O2S B2 S2 | 0.74 V |
| Short FT #1 | 0% |
| Long FT #1 | 17.1% |
| Short FT #2 | 0% |
| Long FT #2 | -6.3% |
| AF Lambda B1 S1 | 1.23 |
| AF Lambda B2 S1 | 0.99 |
| Alcohol Density Estimate | 41% |
| Alcohol Density Learning | Compl |
| AFS Voltage B1 S1 | 3.23 V |
| AFS Voltage B2 S1 | 3.28 V |
| O2S B1 S2 | 0.00 V |
| O2S B2 S2 | 0.68 V |
| Short FT #1 | 0% |
| Long FT #1 | -1.6% |
| Short FT #2 | 2% |
| Long FT #1 | -6.3% |
| AF Lambda B1 S1 | 0.99 |
| AF Lambda B2 S1 | 0.99 |
| Alcohol Density Estimate | 0% |
| Alcohol Density Learning | Compl |
|
| ||||
|
| ||||
|
| ||||
| A | ||
| ||
| 3.CHECK FOR EXHAUST GAS LEAK |
| Result | Proceed to |
| NG | A |
| OK | B |
|
| ||||
| A | ||
| ||
| 4.CHECK FOR EXHAUST GAS LEAK |
|
| ||||
| OK | ||
| ||
| 5.CHECK DTC OUTPUT (DTC P0420 AND/OR P0430) |
According to the output DTCs in the step 1 (Check any other DTCs output), proceed to next step referring to the table below.
| Result | Proceed to |
| P0420 is output | A |
| P0430 is output | B |
| P0420 and P0430 are output | A and B |
|
| ||||
| A | ||
| ||