DYNAMIC LASER CRUISE CONTROL SYSTEM > Wiper Signal Circuit |

| 1.INSPECT WIPER SYSTEM |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (DISTANCE CONTROL ECU - WINDSHIELD WIPER SWITCH) |
![]() |
Disconnect the A43 distance control ECU connector and H15 windshield wiper switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A43-2 (WIP2) - H15-4 (+2) | Always | Below 1 Ω |
| H15-4 (+2) - Body ground | Always | 10 kΩ or higher |
Reconnect the distance control ECU connector and windshield wiper switch connector.
|
| ||||
| OK | ||
| ||