Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM

AIRBAG SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use these procedures to troubleshoot the airbag system.
  2. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.CHECK CAN COMMUNICATION SYSTEM*
    1. Check for DTCs (Click here).
      Result 
      Result
      Proceed to
      DTC is not output
      A
      DTC is output
      B



    B.
    GO TO CAN COMMUNICATION SYSTEM (Click here)
    A


    4.WARNING LIGHT CHECK

      NEXT


      5.CHECK DTC (Present and Past DTCs)*
      1. Check for DTCs (Click here).
        Result 
        Result
        Proceed to
        DTC is output
        A
        DTC is not output
        B



      B.
      PROBLEM SYMPTOMS TABLE (Click here)
      A


      6.DTC CHART

        NEXT


        7.CIRCUIT INSPECTION*

          NEXT


          8.REPAIR

            NEXT


            9.CLEAR DTC (Present and Past DTCs)*

              NEXT


              10.CHECK DTC (Present and Past DTCs)*
              1. Check for DTCs (Click here).
                Result 
                Result
                Proceed to
                DTC is not output
                A
                DTC is output
                B



              B.
              DIAGNOSTIC TROUBLE CODE CHART (Click here)
              A


              11.CONFIRMATION TEST*

                NEXT

                END