VEHICLE STABILITY CONTROL SYSTEM > Skid Control Buzzer Circuit |

| 1.PERFORM ACTIVE TEST USING TECHSTREAM (SKID CONTROL BUZZER) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream ON.
Select the Active Test mode and operate the skid control buzzer using the Techstream.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Buzzer | Skid control buzzer | Buzzer ON/OFF | Buzzer can be heard |
Check that the buzzer sounds/stops when turning the skid control buzzer on/off by using the Techstream.
| Result | Proceed to |
| Buzzer does not sound or sounds constantly | A |
| Buzzer sounds/stops | B |
|
| ||||
| A | |
| 2.INSPECT SKID CONTROL BUZZER (POWER SOURCE TERMINAL) |
![]() |
Disconnect the H5 buzzer connector.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| H5-2 - Body ground | Ignition switch ON | 11 to 14 V |
|
| ||||
| OK | |
| 3.INSPECT SKID CONTROL BUZZER |
![]() |
Disconnect the H5 buzzer connector.
Apply battery negative voltage to terminal 1, and battery positive voltage to terminal 2 of the skid control buzzer, and then check that the buzzer sounds.
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - SKID CONTROL BUZZER) |
![]() |
Disconnect the A19 ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A19-8 (BZ) - H5-1 | Always | Below 1 Ω |
| A19-8 (BZ) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - BODY GROUND) |
![]() |
Disconnect the A19 ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A19-1 (GND1) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||