Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM

AIRBAG SYSTEM > SRS Warning Light does not Come ON

for Preparation Click here


DESCRIPTION

Refer to "SRS Warning Light Remains ON" .

WIRING DIAGRAM

Refer to "SRS Warning Light Remains ON" .

INSPECTION PROCEDURE

1.CHECK BATTERY
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    Battery
    Always
    11 to 14 V



NG
CHECK AND REPLACE BATTERY OR CHARGING SYSTEM
OK


2.CHECK CONNECTOR
  1. Turn the ignition switch off.

  1. Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.

  1. Check that the connectors are properly connected to the combination meter.

    OK:
    The connectors are properly connected.



NG
CONNECT CONNECTOR PROPERLY
OK


3.CHECK HARNESS AND CONNECTOR (SOURCE VOLTAGE OF COMBINATION METER)
C159168E06
  1. Turn the ignition switch off.

  1. Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.

  1. Disconnect the connector from the combination meter.

  1. Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.

  1. Turn the ignition switch to ON.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    H37-20 (IG+) - H37-40 (E1)
    Ignition switch ON
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK SRS WARNING LIGHT
  1. Turn the ignition switch off.

  1. Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.

  1. Disconnect the connectors from the center airbag sensor.

  1. Connect the connector to the combination meter.

  1. Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.

  1. Turn the ignition switch to ON.

  1. Check the SRS warning light condition.

    OK:
    After the primary check period, SRS warning light goes off for approximately 10 seconds and remains on.

    HINT:
    The primary check period is approximately 6 seconds after the ignition switch is turned to ON.



NG
REPLACE COMBINATION METER (Click here)
OK

REPLACE CENTER AIRBAG SENSOR ASSEMBLY (Click here)