Home › Engine / Hybrid System ยท 2UZ-FE › FUEL › FUEL PUMP

FUEL PUMP > INSTALLATION

for Preparation Click here



1. INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY
  1. Apply a light coat of gasoline or grease to a new gasket, and install it to the fuel tank.



    A152236E01
  1. Install the fuel suction with pump and gauge tube assembly into the fuel tank.

    NOTICE:
    1. Be careful not to bend the arm of the fuel suction with pump and gauge tube assembly.
    2. Align the protrusion of the fuel suction with pump and gauge tube assembly with the groove of the fuel tank.

  1. Put the retainer on the fuel tank. While holding the fuel suction with pump and gauge tube assembly, tighten the retainer one complete turn by hand.



    A156395E01
  1. Using SST, tighten the retainer until the mark on the retainer is within range A on the fuel tank, as shown in the illustration.

    SST
    09808-14020  

    HINT:
    Fit the tips of SST onto the ribs of the retainer.



    A152247
    A118171E02
  1. Install the 2 fuel tank tubes with the 2 tube joint clips.

    NOTICE:
    1. Check that there are no scratches or foreign objects on the connecting parts.
    2. Check that the fuel tube joints are inserted securely.
    3. Check that the tube joint clips are on the collars of the fuel tube joints.
    4. After installing the tube joint clips, check that the fuel tube joints have not been pulled off.



2. INSTALL FUEL TANK ASSEMBLY
  1. Install the fuel tank assembly (Click here).