SEAT POSITION SENSOR > INSTALLATION |
| 1. INSTALL SEAT POSITION AIRBAG SENSOR (for Manual Seat) |
Check that the ignition switch is turned off.
Check that the battery negative (-) terminal is disconnected.
![]() |
Using an 1 mm (0.039 in.) feeler gauge, install the seat position airbag sensor.
![]() |
Using "TORX" socket wrench, tighten the "TORX" screw to install the seat position airbag sensor.
Make sure that the clearance between the seat position airbag sensor and the seat rail is between 0.6 mm (0.023 in.) and 2 mm (0.079 in.).
Connect the connector to the seat position airbag sensor.
Check that there is no looseness in the installation parts of the seat position airbag sensor.
Engage the pin and install a new seat position sensor protector.
| 2. INSTALL SEAT POSITION AIRBAG SENSOR (for Power Seat) |
Check that the ignition switch is turned off.
Check that the battery negative (-) terminal is disconnected.
![]() |
Using an 1 mm (0.039 in.) feeler gauge, install the seat position airbag sensor.
![]() |
Using "TORX" socket wrench, tighten the "TORX" screw to install the seat position airbag sensor.
Make sure that the clearance between the seat position airbag sensor and the seat rail is between 0.6 mm (0.023 in.) and 2 mm (0.079 in.).
Connect the connector to the seat position airbag sensor.
Check that there is no looseness in the installation parts of the seat position airbag sensor.
Engage the pin and install a new seat position sensor protector.
| 3. INSTALL FRONT SEAT CUSHION SHIELD (for Manual Seat) |
![]() |
Connect the connector and install the harness to the front seat cushion shield.
Engage the 3 claws in the order shown in the illustration, and install the front seat cushion shield.
Install the 3 screws.
![]() |
Using hog ring pliers, install the rubber band of the seatback cover to the seat frame with 2 new hog rings.
| 4. INSTALL FRONT SEAT ASSEMBLY LH (for Manual Seat) |
Install the front seat assembly (Click here).
| 5. INSTALL FRONT SEAT ASSEMBLY LH (for Power Seat) |
Install the front seat assembly (Click here).
| 6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 7. INSPECT SRS WARNING LIGHT |