Home › Drivetrain ยท AXLE AND DIFFERENTIAL › STEERING KNUCKLE

STEERING KNUCKLE > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the LH side and RH side.
  2. The procedure listed below is for the LH side.



1. INSTALL KNUCKLE GREASE RETAINER CAP LH (for 2WD)


    F042765
  1. Using a brass bar and hammer, tap in a new retainer cap.

    NOTICE:
    1. The retainer cap is a non-reusable part.
    2. Do not damage the retainer cap.



2. INSTALL STEERING KNUCKLE OIL SEAL LH


    C179621E01
  1. Using SST and a press, press in a new oil seal.

    SST
    09950-60020   (09951-01030)
    09950-70010   (09951-07100)

    NOTICE:
    1. The oil seal is a non-reusable part.
    2. Do not damage the steering knuckle oil seal.



3. INSTALL STEERING KNUCKLE LH
  1. Install the front suspension upper arm to the steering knuckle with the nut.

    Torque:
    110 N*m{ 1122 kgf*cm , 81 ft.*lbf }

  1. Install a new clip.

    HINT:
    If the holes for the clip are not aligned, tighten the nut up to another 60°.



4. CONNECT FRONT LOWER BALL JOINT ATTACHMENT LH


C155985
  1. Connect the attachment to the steering knuckle with the 2 bolts.

    Torque:
    300 N*m{ 3059 kgf*cm , 221 ft.*lbf }



5. CONNECT TIE ROD END SUB-ASSEMBLY LH
  1. Connect the tie rod end LH to the steering knuckle with the nut.

    Torque:
    69 N*m{ 704 kgf*cm , 51 ft.*lbf }

  1. Install a new cotter pin.

    HINT:
    Further tighten the nut up to 60° if the holes for the cotter pin are not aligned.



6. INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH
  1. Install the front axle hub (Click here).



7. CONNECT FRONT SPEED SENSOR LH


    C159315
  1. Connect the front speed sensor to the steering knuckle with the bolt.

    Torque:
    11 N*m{ 107 kgf*cm , 8 ft.*lbf }

  1. Attach the clip to the steering knuckle.



8. INSTALL FRONT WHEEL
  1. for Aluminum Wheel

Torque:
131 N*m{ 1336 kgf*cm , 97 ft.*lbf }

  1. for Steel Wheel

Torque:
209 N*m{ 2131 kgf*cm , 154 ft.*lbf }



9. CHECK SPEED SENSOR SIGNAL
  1. Check the speed sensor signal (Click here).



10. INSPECT SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).



11. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
  1. Inspect and adjust the front wheel alignment (Click here).