REAR DIFFERENTIAL CARRIER ASSEMBLY > INSTALLATION |
| 1. INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY |
Using a jack, slowly raise the rear differential carrier assembly to its installation position.
![]() |
Temporarily install the 6 bolts.
Tighten the 4 bolts in order, from A to D.
| 2. INSTALL REAR DRIVE SHAFT ASSEMBLY LH |
| 3. INSTALL REAR DRIVE SHAFT ASSEMBLY RH |
| 4. INSTALL PROPELLER SHAFT ASSEMBLY (for 4WD) |
| 5. INSTALL PROPELLER SHAFT ASSEMBLY (for 2WD) |
| 6. ADD DIFFERENTIAL OIL |
![]() |
Add differential oil so that the oil level is between 0 to 5 mm (0 to 0.197 in.) from the bottom lip of the differential filler plug hole.
| Item | Oil Type and Viscosity |
| Front differential | Toyota Genuine Differential gear oil LT 75W-85 GL-5 or equivalent. |
| Rear differential |
| Specified Condition | |
| 2.05 to 2.15 liters (2.2 to 2.3 US qts., 1.8 to 1.9 Imp. qts.) |
| Specified Condition | |
| 1.50 to 1.60 liters (1.6 to 1.7 US qts., 1.3 to 1.4 Imp. qts.) |
for Rear Differential:
Using a 10 mm hexagon wrench, install a new gasket and the filler plug.
for Front Differential:
Using a 10 mm hexagon wrench, install a new gasket and the filler plug.
| 7. INSPECT FOR OIL LEAK |