Home › Audio/Visual/Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM

DTC    01-DC    Transmission Error

for Preparation Click here


DESCRIPTION


DTC Code
DTC Detection Condition
Trouble Area
01-DC
Transmission to component shown by sub-code is failed.
(Detecting this DTC does not always mean actual failure.)
If same sub-code is recorded in other components, check harness for power supply and communication system of all components shown by code

HINT:
This code may be stored if the engine started, idled 60 seconds and then the ignition switch is turned to the start position again.

NOTICE:
  1. The navigation receiver assembly is the master unit.
  2. Be sure to clear and recheck DTCs after the inspection is completed to confirm that no DTCs are output.


INSPECTION PROCEDURE

NOTICE:
Be sure to read the DESCRIPTION before performing the following procedures.

1.CHECK FOR DTC OF OTHER COMPONENTS
  1. Check if the component shown by the sub-code is displayed in the check result of the other components.

    1. Check if "01-DC" is output for the other components.

  1. If "01-DC" is output for any other components, check if the same physical address is displayed.

    HINT:
    For the list of the components shown by sub-codes, refer to the table in the next step.

    Result 
    Result
    Proceed to
    "01-DC" is output and the same physical address is displayed
    A
    "01-DC" is not output or the same physical address is not displayed
    B



B
Go to step 4
A


2.IDENTIFY COMPONENT WHICH HAS STORED THIS CODE


    E138069E02
  1. Enter the diagnostic mode.

  1. Press the "LAN Mon" switch to change to "LAN Monitor" mode.

  1. Identify the component which has stored this code.
    Component Table 
    Display
    Component
    AVN
    Navigation receiver assembly
    DSP-AMP
    Stereo component amplifier assembly
    Rr-TV*
    Television display assembly

    HINT:
    1. "DSP-AMP" is the component which has stored this code in the example shown in the illustration.
    2. *: w/ Rear Seat Entertainment System


NEXT


3.CHECK COMPONENT WHICH HAS STORED THIS CODE
  1. Select the component which has stored this code.

    Component Table 
    Component
    Proceed to
    Navigation receiver assembly (AVN)
    Navigation receiver communication error (Click here)
    Stereo component amplifier assembly (DSP-AMP)
    Stereo component amplifier communication error (Click here)
    Television display assembly (Rr-TV)*
    Television display communication error (Click here)

    HINT:
    *: w/ Rear Seat Entertainment System


NEXT

END 

4.CLEAR DTC
  1. Clear the DTCs (Click here).

    HINT:
    If "01-DC" is output for only one component, this may not indicate a malfunction.


NEXT


5.RECHECK DTC
  1. Recheck for DTCs and check if the same trouble occurs again.

    OK:
    Malfunction disappears.



NG
Go to step 6
OK

USE SIMULATION METHOD TO CHECK (Click here)  

6.CHECK COMPONENT WHICH HAS STORED THIS CODE
  1. Select the component which has stored this code.

    Component Table 
    Component
    Proceed to
    Navigation receiver assembly (AVN)
    Navigation receiver communication error (Click here)
    Stereo component amplifier assembly (DSP-AMP)
    Stereo component amplifier communication error (Click here)
    Television display assembly (Rr-TV)*
    Television display communication error (Click here)

    HINT:
    *: w/ Rear Seat Entertainment System


NEXT

END