Home › Audio/Visual/Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Stereo Component Amplifier Communication Error

for Preparation Click here


INSPECTION PROCEDURE

1.IDENTIFY COMPONENT SHOWN BY SUB-CODE


    E138069E03
  1. Enter the diagnostic mode.

  1. Press the "LAN Mon" switch to change to "LAN Monitor" mode.

  1. Identify the component shown by the sub-code.

    HINT:
    1. "140 (navigation receiver)" is the component shown by the sub-code in the example shown in the illustration.
    2. The sub-code will be indicated by its physical address.
    3. For the component list, refer to "Diagnosis Display Detailed Description" (Click here).


NEXT


2.CHECK POWER SOURCE CIRCUIT OF COMPONENT SHOWN BY SUB-CODE
  1. Inspect the power source circuit of the component shown by the sub-code.
    Component Table 
    Component
    Proceed to
    Navigation receiver (140)
    Navigation Receiver Assembly Power Source Circuit (Click here)
    Television display (1B0)*
    Television Display Power Source Circuit (Click here)*

    HINT:
    1. *: w/ Rear Seat Entertainment System
    2. If the power source circuit is operating normally, proceed to the next step.


NEXT


3.INSPECT NAVIGATION RECEIVER ASSEMBLY


    E145834E12
  1. Disconnect the I20 and I25* navigation receiver assembly connectors.

    HINT:
    *: w/ Rear Seat Entertainment System

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I20-5 (ATX+) - I20-15 (ATX-)
    Always
    60 to 80 Ω
    I25-9 (TXM+) - I25-10 (TXM-)*

    HINT:
    *: w/ Rear Seat Entertainment System

  1. Reconnect the navigation receiver assembly connectors.



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK


4.CHECK HARNESS AND CONNECTOR (STEREO COMPONENT AMPLIFIER - COMPONENT SHOWN BY SUB-CODE)

HINT:
  1. Start the check from the circuit that is near the component shown by the sub-code first.
  2. For details of the connectors, refer to "Terminals of ECU" (Click here).



  1. Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the stereo component amplifier assembly and the component shown by the sub-code.

    1. Disconnect all connectors between the stereo component amplifier and the component shown by sub-code.



    2. Check for an open or short in the AVC-LAN circuit between the stereo component amplifier and the component shown by the sub-code.

      OK:
      There is no open or short circuit.


      E138055E05


      E145835E05



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.REPLACE COMPONENT SHOWN BY SUB-CODE
  1. Replace the component shown by the sub-code with a normal one and check if the same problem occurs again.

    OK:
    Same problem does not occur.



NG
REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY (Click here)
OK

END