DTC 01-DF Master Error |
| DTC Code | DTC Detection Condition | Trouble Area |
| 01-DF* | When either condition below is met:
|
|
| 1.CHECK NAVIGATION RECEIVER ASSEMBLY POWER SOURCE CIRCUIT |
Refer to the navigation receiver assembly power source circuit (Click here).
If the power source circuit is operating normally, proceed to the next step.
| NEXT | |
| 2.INSPECT NAVIGATION RECEIVER ASSEMBLY |
![]() |
Disconnect the I20 and I25* navigation receiver assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I20-5 (ATX+) - I20-15 (ATX-) | Always | 60 to 80 Ω |
| I25-9 (TXM+) - I25-10 (TXM-)* |
Reconnect the navigation receiver assembly connectors.
|
| ||||
| OK | |
| 3.IDENTIFY COMPONENT WHICH HAS STORED THIS CODE |
![]() |
Enter the diagnostic mode.
Press the "LAN Mon" switch to change to "LAN Monitor" mode.
Identify the component which has stored this code.
| Display | Component |
| DSP-AMP | Stereo component amplifier assembly |
| Rr-TV* | Television display assembly |
| NEXT | |
| 4.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - COMPONENT WHICH HAS STORED THIS CODE) |
Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the navigation receiver assembly and the component which has stored this code.
Disconnect all connectors between the navigation receiver assembly and the component which has stored this code.
Check for an open or short in the AVC-LAN circuit between the navigation receiver assembly and the component which has stored this code.


|
| ||||
| OK | |
| 5.REPLACE NAVIGATION RECEIVER ASSEMBLY |
Replace the navigation receiver assembly with a normal one (Click here).
Check if the same problem occurs again.
|
| ||||
| OK | ||
| ||