TIRE PRESSURE WARNING SYSTEM > ECU Power Source Circuit |

| 1.INSPECT FUSE (ECU-IG NO. 1) |
![]() |
Remove the ECU-IG No. 1 fuse from the main body ECU.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| ECU-IG No. 1 fuse | Always | Below 1 Ω |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (ECU - BATTERY AND BODY GROUND) |
Disconnect the H40 ECU connector.
![]() |
Measure the voltage and resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| H40-7 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| Tester Connection | Condition | Specified Condition |
| H40-9 (GND) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (ECU - BATTERY) |
Disconnect the H40 ECU connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| H40-7 (IG) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||