DTC U0101 Lost Communication with TCM |
| DTC No. | DTC Detection Condition | Trouble Area |
| U0101 | No communication from TCM continues |
|
| Related DTCs | U0101: Verify communication |
| Required Sensors/Components (Main) | ECM |
| Required Sensors/Components (Sub) | - |
| Frequency of Operation | Continuous |
| Duration | 1.25 seconds |
| MIL Operation | Immediate |
| Sequence of Operation | None |
| Monitor runs whenever following DTCs are not present | None |
| Battery voltage | 10.5 V or more |
| Ignition switch | ON |
| Starter | OFF |
| Communication signal | Lost communication with TCM |
| 1.CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC U0101) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream ON.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| U0101 is output | A |
| U0101 and other DTCs are output | B |
|
| ||||
| A | |
| 2.REPLACE ECM |
Replace the ECM (Click here).
| NEXT | |
| 3.CHECK IF DTC RECURS |
Connect the Techstream to the DLC3.
Clear the DTC (Click here).
Start the engine.
Read the DTCs.
| Result | Proceed to |
| No DTC is output | A |
| Other DTCs are output | B |
|
| ||||
| A | ||
| ||