KEY REMINDER WARNING SYSTEM > Key Reminder Buzzer does not Sound |

| 1.CHECK FRONT DOOR COURTESY LIGHT SWITCH LH |
Open the driver door and check that the open door indicator on the combination meter comes on.
|
| ||||
| OK | |
| 2.CHECK UNLOCK WARNING SWITCH |
Check that the security indicator on the accessory meter turns off, when the key is inserts into the ignition key cylinder.
|
| ||||
| OK | |
| 3.READ VALUE USING TECHSTREAM (KEY UNLOCK WARNING SW) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Main Body / Data List/
According to the display on the Techstream, read on the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Key Unlock Warning SW | Unlock warning switch signal/ON or OFF | ON: Key is in ignition key cylinder OFF: No key is in ignition cylinder | - |
|
| ||||
| OK | |
| 4.INSPECT COMBINATION METER ASSEMBLY (BUZZER OPERATION) |
Raise the vehicle with a lift, until the tires are off the ground.
Turn the ignition switch to ON and open any door.
Rotate the wheel at a speed of 5 km/h (3.1 mph) or more.
Check that the door ajar driving warning buzzer sounds to inform that the door is ajar while the vehicle is moving.
|
| ||||
| OK | ||
| ||