Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING ECU

TIRE PRESSURE WARNING ECU > INSTALLATION

for Preparation Click here



1. INSTALL TIRE PRESSURE WARNING ECU


    C178149
  1. Install the tire pressure warning ECU with the 2 nuts.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 ft.*lbf }

  1. Connect the tire pressure warning ECU connector.



2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH


    B192341
  1. Engage the 4 claws and install the finish panel.

  1. Install the 3 <D> screws and bolt <A>.



3. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


B192340
  1. Engage the 2 guides and 4 claws and install the under cover.



4. INSTALL INSTRUMENT SIDE PANEL RH


    B192339
  1. Engage the 3 guides and 3 claws and install the side panel.



5. INSTALL COWL SIDE TRIM BOARD RH


    B190152
  1. Engage the 2 clips to install the cowl side trim board.

  1. Install the clip.



6. INSTALL FRONT DOOR SCUFF PLATE RH


B190151
  1. Engage the 9 claws to install the scuff plate.



7. REGISTRATION TRANSMITTER ID
(Click here)


8. INSPECT TIRE PRESSURE WARNING SYSTEM
(Click here)


9. INITIALIZE SYSTEM
(Click here)