THEFT DETERRENT SYSTEM > Security Indicator Light Circuit |

| 1.PERFORM ACTIVE TEST USING TECHSTREAM |
Connect a Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream main switch on.
Select the item below in the Active Test and then check that the indicator operates.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Security Indicator | Security indicator | ON/OFF | - |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (SECURITY INDICATOR - MAIN BODY ECU) |
![]() |
Disconnect the H1 maim body ECU connector.
Disconnect the I22 accessory meter connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| H1-4 (IND) - I22-16 (MHTR) | Always | Below 1 Ω |
| H1-4 (IND) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (SECURITY INDICATOR - BODY GROUND) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I22-12 (E) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 4.INSPECT ACCESSORY METER ASSEMBLY |
![]() |
Reconnect the I22 accessory meter connector with the H1 main body ECU connector still disconnected.
Apply battery voltage from the wire harness back side between the specified terminals of the indicator, and check the lighting condition of the security indicator.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal I22-16 (MHTR) Battery negative (-) → Terminal I22-12 (E) | Security indicator comes on |
|
| ||||
| OK | ||
| ||