TRANSFER ASSEMBLY > INSTALLATION |
| 1. INSTALL TRANSFER ASSEMBLY |
![]() |
Install the transfer with the 8 bolts.
| 2. INSTALL AUTOMATIC TRANSMISSION (for A750F) |
Install the automatic transmission with transfer assembly (Click here).
| 3. INSTALL AUTOMATIC TRANSMISSION (for AB60F) |
Install the automatic transmission with transfer assembly (Click here).
| 4. ADD TRANSFER OIL |
Install a new gasket and the drain plug.
Pour oil so that the oil level is between 0 to 5.0 mm (0 to 0.197 in.) from the bottom lip of the filler plug hole.
Wait approximately 5 minutes and check that the oil level has not changed.
Install a new gasket and the filler plug.
![]() |
Install the lower transfer case protector with the 4 bolts.
| 5. CHECK TRANSFER OIL |
Remove the filler plug and gasket.
![]() |
Check that the oil level is between 0 to 5.0 mm (0 to 0.197 in.) from the bottom lip of the filler plug hole.
If the result is not as specified, add transfer oil.
When the oil level is too low, check for oil leak.
Install a new gasket into the filler plug and then tighten the plug.
| 6. INSPECT FOR TRANSFER OIL LEAK |