Home › Audio/Visual/Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM

DTC    5C-40    Camera Picture Error

for Preparation Click here


DESCRIPTION


DTC Code
DTC Detection Condition
Trouble Area
5C-40
Synchronous signal from camera cannot be transmitted.
  1. Harness and connector
  2. Television camera assembly
  3. Navigation receiver assembly

WIRING DIAGRAM


E126423E33


INSPECTION PROCEDURE

HINT:
After the inspection is completed, clear the DTCs (Click here).

1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - TELEVISION CAMERA)


    E160631E01
  1. Disconnect the I7 navigation receiver assembly connector.

  1. Disconnect the V17 television camera assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    V17-4 (CB+) - I7-24 (CA+)
    Always
    Below 1 Ω
    V17-3 (CGND) - I7-21 (CGND)
    V17-2 (CV+) - I7-22 (V+)
    V17-1 (CV-) - I7-23 (V-)
    V17-4 (CB+) - Body ground
    Always
    10 kΩ or higher
    V17-3 (CGND) - Body ground
    V17-2 (CV+) - Body ground
    V17-1 (CV-) - Body ground

  1. Reconnect the navigation receiver assembly connector.

  1. Reconnect the television camera assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT NAVIGATION RECEIVER ASSEMBLY (CA+ VOLTAGE)


    I102033E07
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    I7-24 (CA+) - I7-21 (CGND)
    Ignition switch ON, shift lever in R
    5.5 to 7.05 V



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK

REPLACE TELEVISION CAMERA ASSEMBLY (Click here)