REAR DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL > REPLACEMENT |
| 1. DRAIN DIFFERENTIAL OIL |
Stop the vehicle on a level place.
for Front Differential:
Using a 10 mm hexagon wrench, remove the filler plug and gasket.
Using a 10 mm hexagon wrench, remove the drain plug and gasket, and drain the oil.
Using a 10 mm hexagon wrench, install a new gasket and the drain plug.
for Rear Differential:
Using a 10 mm hexagon wrench, remove the filler plug and gasket.
Using a 10 mm hexagon wrench, remove the drain plug and gasket, and drain the oil.
Using a 10 mm hexagon wrench, install a new gasket and the drain plug.
| 2. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH |
Remove the front drive shaft (Click here).
| 3. REMOVE DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL |
![]() |
Using SST, tap out the 2 oil seals.
| 4. INSTALL DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL |
![]() |
Apply MP grease to 2 new oil seals.
Using SST and a hammer, tap in the 2 oil seals.
| 5. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH |
Install the front drive shaft (Click here).
| 6. ADD DIFFERENTIAL OIL |
![]() |
Add differential oil so that the oil level is between 0 to 5 mm (0 to 0.197 in.) from the bottom lip of the differential filler plug hole.
| Item | Oil Type and Viscosity |
| Front differential | Toyota Genuine Differential gear oil LT 75W-85 GL-5 or equivalent. |
| Rear differential |
| Specified Condition | |
| 2.05 to 2.15 liters (2.2 to 2.3 US qts., 1.8 to 1.9 Imp. qts.) |
| Specified Condition | |
| 1.50 to 1.60 liters (1.6 to 1.7 US qts., 1.3 to 1.4 Imp. qts.) |
for Rear Differential:
Using a 10 mm hexagon wrench, install a new gasket and the filler plug.
for Front Differential:
Using a 10 mm hexagon wrench, install a new gasket and the filler plug.
| 7. INSPECT FOR OIL LEAK |