DYNAMIC LASER CRUISE CONTROL SYSTEM > Laser Sensor Power Source Circuit |

| 1.CHECK HARNESS AND CONNECTOR (IGB VOLTAGE) |
![]() |
Disconnect the A26 laser radar sensor connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A26-5 (IGB) - Body ground | Ignition switch ON | 11 to 14 V |
Reconnect the laser radar sensor connector.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (LASER RADAR SENSOR - ECM AND BODY GROUND) |
![]() |
Disconnect the A27 connector from the ECM.
Disconnect the A26 connector from the laser radar sensor.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A27-44 (LGND) - A26-1 (LGND) | Always | Below 1 Ω |
| A26-1 (LGND) - Body ground | Always | 10 kΩ or higher |
| A26-2 (SGND) - Body ground | Always | Below 1 Ω |
Reconnect the ECM and laser radar sensor connector.
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (LASER RADAR SENSOR - DISTANCE CONTROL ECU) |
![]() |
Disconnect the A43 distance control ECU connector.
Disconnect the A26 laser radar sensor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A26-5 (IGB) - A43-13 (IGB) | Always | Below 1 Ω |
| A43-13 (IGB) - Body ground | Always | 10 kΩ or higher |
Reconnect the ECU and laser radar sensor connector.
|
| ||||
| OK | ||
| ||