RADIATOR > REMOVAL |
| 1. REMOVE NO. 1 ENGINE UNDER COVER |
![]() |
Remove the 3 screws and 5 bolts.
Unhook the engine under cover from the vehicle body as shown in the illustration.
| 2. DRAIN ENGINE COOLANT |
Loosen the radiator drain cock plug.
Remove the radiator cap. Then drain the coolant from the radiator.
Loosen the 2 cylinder block drain cock plugs. Then drain the coolant from the engine.
Tighten the 2 cylinder block drain cock plugs.

Tighten the radiator drain cock plug by hand.
| 3. REMOVE FRONT BUMPER COVER ASSEMBLY |
Remove the front bumper cover assembly (Click here).
| 4. REMOVE NO. 1 FRONT BUMPER SIDE RETAINER SUB-ASSEMBLY RH (w/ Trailer Towing System) |
| 5. REMOVE OIL COOLER ASSEMBLY (w/ Trailer Towing System) |
![]() |
Remove the 5 nuts and oil cooler from the oil filter bracket.
![]() |
Remove the 2 O-rings.
| 6. REMOVE V-BANK COVER SUB-ASSEMBLY |
![]() |
Raise the front of the V-bank cover to detach the 2 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.
| 7. REMOVE INLET RADIATOR HOSE |
![]() |
Remove the inlet radiator hose.
| 8. DISCONNECT OUTLET RADIATOR HOSE |
![]() |
Disconnect the outlet radiator hose from the water inlet housing.
| 9. REMOVE FAN SHROUD (w/ Trailer Towing System) |
![]() |
Loosen the 4 nuts holding the fluid coupling and fan.
Remove the fan and generator V belt .
![]() |
Detach the claw to open the No. 1 flexible hose clamp.
![]() |
Disconnect the reservoir hose from the upper radiator tank.
Remove the 2 bolts holding the fan shroud.
Remove the 4 nuts of the fluid coupling fan, and then remove the shroud together with the coupling fan.
Remove the fan pulley from the fan bracket.
| 10. REMOVE FAN SHROUD (w/o Trailer Towing System) |
![]() |
Loosen the 4 nuts holding the fluid coupling fan.
Remove the fan and generator V belt .
![]() |
Disconnect the reservoir hose from the upper radiator tank.
Remove the 2 bolts holding the fan shroud.
Remove the 4 nuts of the fluid coupling fan, and then remove the shroud together with the coupling fan.
Remove the fan pulley from the fan bracket.
| 11. REMOVE RADIATOR SIDE DEFLECTOR RH (w/o Trailer Towing System) |
![]() |
Remove the 6 clips and side deflector.
| 12. REMOVE RADIATOR SIDE DEFLECTOR LH |
![]() |
Remove the 6 clips and side deflector.
Disconnect the wire harness clamp.
| 13. REMOVE NO. 1 RADIATOR TO SUPPORT SEAL (for LH Side) |
![]() |
Remove the 3 clips and remove the No. 1 radiator to support seal.
| 14. REMOVE NO. 1 RADIATOR TO SUPPORT SEAL (for RH Side) |
![]() |
Remove the 3 clips and remove the No. 1 radiator to support seal.
| 15. REMOVE RADIATOR ASSEMBLY |
![]() |
Remove the 4 bolts and radiator.
| 16. REMOVE OUTLET RADIATOR HOSE |
![]() |
Remove the outlet radiator hose from the radiator.