Home › Engine / Hybrid System ยท 2UZ-FE › COOLING › WATER PUMP

WATER PUMP > INSTALLATION

for Preparation Click here



1. INSTALL WATER PUMP ASSEMBLY


    A122970E01
  1. Install a new O-ring to the water by-pass pipe.

  1. Apply soapy water to the O-ring.

  1. Connect the water pump to the water by-pass pipe end.

  1. Temporarily install the water pump and a new gasket with the 5 bolts, 2 stud bolts and nut. Uniformly tighten the bolts, stud bolts and nut in several passes.

    1. for Bolt

    Torque:
    21 N*m{ 214 kgf*cm , 16 ft.*lbf }

    1. for Stud bolt, nut

    Torque:
    18 N*m{ 183 kgf*cm , 13 ft.*lbf }



2. INSTALL INLET WATER HOUSING


    A122971E03
  1. Apply seal packing in a continuous line to the places shown in the illustration.

    Seal packing:
    Toyota Genuine Seal Packing Black, Three Bond 1215B or equivalent

    Standard seal diameter:
    2.0 to 3.0 mm (0.0787 to 0.118 in.)

    NOTICE:
    1. Remove any oil from the contact surface.
    2. Install the water pump within 3 minutes after applying seal packing.

  1. Apply soapy water to a new O-ring and install it to the water inlet housing.



    A122972E01
  1. Temporarily install the water inlet housing with the 2 bolts. Uniformly tighten the bolts in several steps.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }

    Bolt Length:
    Item
    Length
    Bolt A
    77 mm (3.03 in.)
    Bolt B
    22 mm (0.866 in.)

  1. Connect the water by-pass hose to the water inlet housing.



3. INSTALL TIMING BELT
  1. Remove the timing belt (Click here).



4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

NOTICE:
When disconnecting the cable, some system need to be initialized after the cable is reconnected (Click here).