Home › Engine / Hybrid System ยท 2UZ-FE › COOLING › WATER PUMP

WATER PUMP > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some system need to be initialized after the cable is reconnected (Click here).



2. REMOVE TIMING BELT
Refer to the procedures under " Remove Timing Belt "(Click here).


3. REMOVE INLET WATER HOUSING


    A122973
  1. Disconnect the water by-pass hose from the inlet water housing.

  1. Remove the 2 bolts and inlet water housing with water inlet.

  1. Remove the O-ring from the inlet water housing.



4. REMOVE WATER PUMP ASSEMBLY


    A122974
  1. Remove the 5 bolts, 2 stud bolts, nut, water pump and gasket.

  1. Remove the O-ring from the water by-pass pipe.