Home › Engine / Hybrid System ยท 2UZ-FE › ENGINE MECHANICAL › FRONT CRANKSHAFT OIL SEAL

FRONT CRANKSHAFT OIL SEAL > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some system need to be initialized after the cable is reconnected (Click here)



2. REMOVE TIMING BELT
  1. Remove the timing belt (Click here).



3. REMOVE CRANKSHAFT TIMING PULLEY


    A004445E01
  1. Using SST, remove the timing pulley.

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05010, 09953-05020, 09954-05010)

    NOTICE:
    Do not turn the timing pulley.



4. REMOVE FRONT CRANKSHAFT OIL SEAL


    A004863E02
  1. Using a knife, cut off the lip of the oil seal.

  1. Using a screwdriver, pry out the oil seal.

    NOTICE:
    Do not damage the surface of the oil seal press fit hole and crankshaft.

    HINT:
    Tape the screwdriver tip before use.