Home › Engine / Hybrid System ยท 2UZ-FE › ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL

REAR CRANKSHAFT OIL SEAL > INSTALLATION

for Preparation Click here



1. INSTALL REAR CRANKSHAFT OIL SEAL


    A160780E01
  1. Apply MP grease to the lip of a new oil seal.

  1. Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.

    SST
    09223-56010  

    NOTICE:
    1. Keep the lip free from foreign matter.
    2. Do not tap on the oil seal at an angle.



2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    A160799E01
  1. Using SST, hold the crankshaft.

    SST
    09213-70011  
    09330-00021  

  1. Install the front drive plate spacer, drive plate and rear drive plate spacer on the crankshaft.



    A160778E01
  1. Install and uniformly tighten 8 new bolts in the sequence shown in the illustration.

    Torque:
    30 N*m{ 306 kgf*cm , 22 ft.*lbf }

    NOTICE:
    1. Do not reuse the drive plate installation bolts.
    2. Do not impact or damage the drive plate installation bolts. Be sure to handle them carefully.



    A149106E01
  1. Mark the upside of each drive plate installation bolt with paint.

  1. Retighten the drive plate installation bolts by 90° as shown.

  1. Check that the painted marks are now at a 90° angle to the upside.



3. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY (for 2WD)
  1. Install the automatic transmission assembly (Click here).



4. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY (for 4WD)
  1. Install the automatic transmission assembly (Click here).