Home › Engine / Hybrid System ยท 2UZ-FE › ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL

REAR CRANKSHAFT OIL SEAL > REMOVAL

for Preparation Click here



1. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY (for 2WD)
  1. Remove the automatic transmission assembly (Click here).



2. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY (for 4WD)
  1. Remove the automatic transmission assembly (Click here).



3. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    A160799E01
  1. Using SST, hold the crankshaft.

    SST
    09213-70011  
    09330-00021  



    A160778
  1. Remove the 8 bolts, front drive plate spacer, drive plate and rear drive plate spacer.



4. REMOVE REAR CRANKSHAFT OIL SEAL


    A160779E01
  1. Using a knife, cut off the lip of the oil seal.

  1. Using a screwdriver, pry out the oil seal.

    NOTICE:
    Do not damage the surface of the oil seal press fit hole and crankshaft.

    HINT:
    Tape the screwdriver tip before use.