Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM

DTC    B1615/14    Front Airbag Sensor LH Malfunction

for Preparation Click here


DESCRIPTION

The front airbag sensor LH consists of the diagnostic circuit and the frontal deceleration sensor, etc.
If the center airbag sensor receives signals from the frontal deceleration sensor, it determines whether the SRS should be activated.
DTC B1615/14 is stored when a malfunction is detected in the front airbag sensor LH circuit.

DTC Code
Detection Condition
Trouble Area
B1615/14
When one of following conditions is met:
  1. Front airbag sensor LH malfunction
  2. Center airbag sensor malfunction
  1. Front airbag sensor LH
  2. Center airbag sensor assembly

WIRING DIAGRAM


C162318E10


INSPECTION PROCEDURE

1.CHECK FRONT AIRBAG SENSOR LH
C158831E02
  1. Turn the ignition switch off.

  1. Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.

  1. Interchange the front airbag sensor RH with LH and connect the connectors to them.

  1. Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.

  1. Turn the ignition switch to ON, and wait for at least 60 seconds.

  1. Clear the DTCs stored in the memory (Click here).

  1. Turn the ignition switch off.

  1. Turn the ignition switch to ON, and wait for at least 60 seconds.

  1. Check for DTCs (Click here).
    Result 
    Result
    Proceed to
    DTC B1615/14 is output
    A
    DTC B1610/13 is output
    B
    DTC B1610/13 and B1615/14 are not output
    C

    HINT:
    Codes other than DTC B1610/13 and B1615/14 may be output at this time, but they are not related to this check.



A
REPLACE CENTER AIRBAG SENSOR ASSEMBLY (Click here)

B
REPLACE FRONT AIRBAG SENSOR LH (Click here)
C

USE SIMULATION METHOD TO CHECK (Click here)