Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › INTUITIVE PARKING ASSIST SYSTEM

INTUITIVE PARKING ASSIST SYSTEM > Vehicle Speed Signal Circuit

for Preparation Click here


DESCRIPTION

This circuit sends a speed signal from the combination meter assembly to the clearance warning ECU.

HINT:
  1. A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter. The signal is changed to a pulse signal at the transistor in the combination meter. Each ECU controls its respective system based on the pulse signal.
  2. If a short occurs in any of the ECUs or in the wire harness connected to an ECU, both systems in the diagram below will not operate normally.


WIRING DIAGRAM


E160656E01


INSPECTION PROCEDURE

1.INSPECT OPERATION OF SPEEDOMETER
  1. Drive the vehicle and check if the function of the speedometer on the combination meter is normal.

    OK:
    Actual vehicle speed and the speed indicated on the speedometer are the same.

    HINT:
    1. The speed indicated on the speedometer has an allowable margin of error. This can be tested using a speedometer tester (calibrated chassis dynamometer). For details about testing and the margin of error, refer to "Operation Check" in the meter/gauge system (Click here).
    2. The vehicle speed sensor is functioning normally when the indication on the speedometer is normal.



NG
GO TO METER / GAUGE SYSTEM
OK


2.CHECK COMBINATION METER ASSEMBLY (SPEED SIGNAL)


    B144640E03
  1. Disconnect the H43 clearance warning ECU connector.

  1. Jack up the drive wheels.

  1. Move the shift lever to N.

  1. Turn the ignition switch to ON.

  1. Using an oscilloscope, check the signal waveform of the meter.
    Waveform 
    Tester Connection
    H43-3 (SPD) - Body ground
    Tester Range
    5 V/DIV., 20 msec./DIV.
    Vehicle Condition
    Drive vehicle at 20 km/h (12 mph)

    HINT:
    As the vehicle speed increases, the wave length shortens.

    OK:
    Voltage pulses as shown in the illustration.

  1. Reconnect the clearance warning ECU connector.



NG
Go to step 3
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

3.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - COMBINATION METER ASSEMBLY)


    B144641E03
  1. Disconnect the H43 clearance warning ECU connector.

  1. Disconnect the H37 combination meter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H43-3 (SPD) - H37-35 (+S)
    Always
    Below 1 Ω
    H43-3 (SPD) - Body ground
    Always
    10 kΩ or higher

  1. Reconnect the clearance warning ECU connector.

  1. Reconnect the combination meter assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)