Home › Audio/Visual/Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Microphone Circuit between Microphone and Radio Receiver

for Preparation Click here


DESCRIPTION

This circuit sends a microphone signal from the microphone amplifier assembly to the radio receiver assembly.
It also supplies power from the radio receiver assembly to the microphone amplifier assembly.

WIRING DIAGRAM


E160664E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (TSW- - MGND)


    B110782E27
  1. Disconnect the I9 radio receiver assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I9-3 (TSW-) - I9-6 (MGND)
    Always
    Below 1 Ω
    I9-3 (TSW-) - Body ground
    Always
    10 kΩ or higher

  1. Reconnect the radio receiver assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (MICROPHONE AMPLIFIER ASSEMBLY - RADIO RECEIVER ASSEMBLY)


    E145927E02
  1. Disconnect the U7 roof console box assembly connector.

  1. Disconnect the I9 radio receiver assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    U7-10 (ACC) - I9-7 (MCVD)
    Always
    Below 1 Ω
    U7-9 (MI1+) - I9-2 (MIC+)
    U7-8 (MIC-) - I9-1 (MIC-)
    U7-10 (ACC) - Body ground
    Always
    10 kΩ or higher
    U7-9 (MIC+) - Body ground
    U7-8 (MIC-) - Body ground

  1. Reconnect the roof console box assembly connector.

  1. Reconnect the radio receiver assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT RADIO RECEIVER ASSEMBLY (MCVD VOLTAGE)


    E145932E02
  1. Disconnect the I9 radio receiver assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    I9-7 (MCVD) - Body ground
    Ignition switch ON
    4 to 6 V



NG
REPLACE RADIO RECEIVER ASSEMBLY (Click here)
OK


4.REPLACE MICROPHONE WITH ANOTHER AND CHECK
  1. Replace the telephone microphone assembly with a normal one (Click here).

  1. Check if the same problem occurs again.

    OK:
    Malfunction disappears.



NG
REPLACE ROOF CONSOLE BOX ASSEMBLY (Click here)
OK

END (MICROPHONE IS FAULTY)