Home › Engine / Hybrid System ยท 2UZ-FE › ENGINE CONTROL › KNOCK SENSOR

KNOCK SENSOR > REMOVAL

for Preparation Click here



1. REMOVE INTAKE MANIFOLD ASSEMBLY
  1. Remove the intake manifold (Click here).



2. REMOVE WATER BY-PASS PIPE SUB-ASSEMBLY


    A159345
  1. Disconnect the connector clamp.

  1. Remove the bolt.

  1. Pull out the water by-pass pipe sub-assembly.

  1. Remove the O-ring from the water by-pass pipe sub-assembly.



3. REMOVE NO. 4 AIR INJECTION SYSTEM HOSE


    A185661
  1. Loosen the 2 clips and remove the No. 1 air injection system hose.



4. REMOVE KNOCK SENSOR


    A159538
  1. Disconnect the 2 knock sensor connectors.

  1. Remove the 2 nuts and 2 knock sensors.