Home › Engine / Hybrid System · CRUISE CONTROL › DYNAMIC LASER CRUISE CONTROL SYSTEM

DYNAMIC LASER CRUISE CONTROL SYSTEM > Washer Signal Circuit

for Preparation Click here


DESCRIPTION

The distance control ECU detects washer operation. The cruise control will be cancelled by the distance control ECU if the windshield wipers operate in the HI or LO mode. By detecting washer operation, the distance control ECU allows the cruise control to continue even when the windshield wipers operate in the HI or LO mode.

WIRING DIAGRAM


E163086E02


INSPECTION PROCEDURE

1.CHECK WASHER SYSTEM
  1. Check that the front washer operates.

    OK:
    Washer function is normal.



NG
GO TO WIPER AND WASHER SYSTEM (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (DISTANCE CONTROL ECU - WINDSHIELD WIPER SWITCH)


    E163088E01
  1. Disconnect the A43 distance control ECU connector and H14 windshield wiper switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A43-3 (WASH) - H14-3 (WF)
    Always
    Below 1 Ω
    H14-3 (WF) - Body ground
    Always
    10 kΩ or higher

  1. Reconnect the distance control ECU connector and windshield wiper switch connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)