Home › Power Source / Network · NETWORKING › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > ECM Communication Stop Mode

for Preparation Click here


DESCRIPTION


Detection Item
Symptom
Trouble Area
ECM Communication Stop Mode
When either condition below is met:
  1. Engine is not displayed on "CAN Bus Check".
  2. Applies to "ECM Communication Stop Mode" in "DTC Combination Table".
  1. Power source or ECM
  2. ECM

WIRING DIAGRAM


E158754E02


C194000E01


INSPECTION PROCEDURE

HINT:
Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.

1.CHECK HARNESS AND CONNECTOR (ECM - BATTERY AND BODY GROUND)


    C159492E02
  1. Disconnect the A27 and D56 ECM connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D56-81 (E1) - Body ground
    Always
    Below 1 Ω
    D56-42 (E02) - Body ground
    D56-43 (E01) - Body ground
    D56-82 (ME01) - Body ground

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    A27-1 (BATT) - Body ground
    Always
    11 to 14 V
    A27-2 (+B2) - Body ground
    Battery positive (+) voltage is applied to terminal MREL
    A27-3 (+B) - Body ground
    Battery positive (+) voltage is applied to terminal MREL
    A27-34 (MREL) - Body ground
    Ignition switch off

    Result 
    Result
    Proceed to
    OK (for 2UZ-FE)
    A
    OK (for 3UR-FE)
    B
    OK (for 3UR-FBE)
    C
    NG
    D



B
REPLACE ECM (Click here)

C
REPLACE ECM (Click here)

D
REPAIR OR REPLACE HARNESS OR CONNECTOR
A

REPLACE ECM (Click here)