Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM

DTC    B1442/42    Air Inlet Damper Control Servo Motor Circuit

for Preparation Click here


DESCRIPTION

The recirculation damper servo sends pulse signals to inform the air conditioning amplifier of the damper position. The air conditioning amplifier activates the motor (normal, reverse) based on the signals to move the recirculation damper to any position, which controls the intake air settings (FRESH, FRESH/RECIRCULATION and RECIRCULATION).

HINT:
Confirm that no mechanical problem is present because this diagnostic trouble code can be output when either a damper link or damper is mechanically locked.


DTC Code
DTC Detection Condition
Trouble Area
B1442/42
Recirculation damper position sensor value does not change even if air conditioning amplifier operated recirculation damper servo motor
  1. Recirculation damper servo
  2. Air conditioning harness
  3. Air conditioning amplifier

WIRING DIAGRAM


E156865E23


INSPECTION PROCEDURE

1.READ VALUE USING TECHSTREAM (AIR INLET DAMPER TARGET PULSE)
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Body Electrical / Air Conditioner / Data List / Air Inlet Damper Targ Pulse.

  1. According to the display on the Techstream, read the Data List.

    Air Conditioner 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Air Inlet Damper Targ Pulse
    Air inlet damper target pulse /
    Min.: 0
    Max.: 255
    REC: 7
    FRS: 28
    -

    OK:
    The display is as specified in the normal condition.


    Result 
    Result
    Proceed to
    NG
    A
    OK (When troubleshooting according to Problem Symptoms Table)
    B
    OK (When troubleshooting according to the DTC output)
    C



B
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

C
REPLACE AIR CONDITIONING AMPLIFIER (Click here)
A


2.REPLACE RECIRCULATION DAMPER SERVO
  1. Temporarily replace the recirculation damper servo with a new one (Click here).

    HINT:
    Since the damper servo cannot be inspected while it is removed from the vehicle, replace the damper servo with a new one and check that the condition returns to normal.


NEXT


3.CHECK FOR DTC
  1. Clear the DTC (Click here).

  1. Check for DTC (Click here).

    OK:
    DTC is not output.



NG
Go to step 4
OK

END (RECIRCULATION DAMPER SERVO IS DEFECTIVE) 

4.REPAIR OR REPLACE AIR CONDITIONING HARNESS
  1. Repair or replace the air conditioning harness (Click here ).


NEXT


5.CHECK FOR DTC
  1. Clear the DTC (Click here).

  1. Check for DTC again (Click here).

    OK:
    DTC is not output.



NG
REPLACE AIR CONDITIONING AMPLIFIER (Click here)
OK

END