REAR SEAT CUSHION HEATER > INSTALLATION |
| 1. INSTALL SEAT CUSHION HEATER ASSEMBLY |
![]() |
Set the seat cushion heater with the name stamp side facing the seat cushion cover.
Install the seat cushion heater with new 31 tack pins.
| 2. INSTALL SEPARATE TYPE REAR SEAT CUSHION COVER |
![]() |
Using hog ring pliers, install the seat cushion cover to the seat cushion pad with 11 new hog rings.
| 3. INSTALL SEAT CUSHION COVER WITH PAD |
![]() |
Engage the hooks to install the rear seat cushion spring assembly.
![]() |
Using hog ring pliers, install the seat cushion spring with 9 new hog rings.
| 4. INSTALL REAR NO. 1 SEAT CUSHION ASSEMBLY RH |
![]() |
Install the 2 bushes to the cushion spring. Then, using a T45 "TORX" socket, install the 2 bolts.
Install the 2 bolts.
![]() |
Fasten the cable to the seat cushion spring with 2 cable ties and connect the cable.
![]() |
Fasten the cable with a cable tie.
Engage the cable clamp and connect the cable to the seat cushion spring.
![]() |
Fasten the cable to the seat cushion spring with a cable tie and connect the cable.
![]() |
Connect the connector and engage the 3 harness clamps.
| 5. INSTALL REAR SEAT CUSHION HINGE COVER NO. 2 |
![]() |
Engage the 2 claws to install the rear seat cushion hinge cover.
Install the screw.
| 6. INSTALL REAR SEAT CUSHION HINGE COVER NO. 3 |
![]() |
Engage the 2 claws to install the rear seat cushion hinge cover.
Install the screw.
| 7. INSTALL REAR SEAT RECLINING RELEASE LEVER |
![]() |
Install the rear seat reclining release lever with the 3 screws.
| 8. INSTALL RECLINING ADJUSTER KNOB CAP RH |
![]() |
Engage the 3 claws and install the reclining adjuster knob cap.
![]() |
Press the pink button on the rear seatback lock control No. 1 cable to release the cable lock, operate the lever a few times to adjust the amount of cable play, and then push in the pink button to lock the cable.
| 9. INSTALL REAR NO. 1 SEAT ASSEMBLY RH |
Install the rear No. 1 seat assembly (Click here).