DTC B1661/44 Roll Over Cut Off Indicator Malfunction |
| DTC Code | Detection Condition | Trouble Area |
| B1661/44 |
|
|

| 1.CHECK COMBINATION METER (SOURCE VOLTAGE) |
![]() |
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Remove the combination meter with connect connector.
Disconnect the connector from the center airbag sensor.
Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| H37-6 (SW) - Body ground | Ignition switch ON | 11 to 14 V |
|
| ||||
| OK | |
| 2.CHECK INSTRUMENT PANEL WIRE (CENTER AIRBAG SENSOR - COMBINATION METER AND BODY GROUND) |
![]() |
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Disconnect the connector from the center airbag sensor and combination meter.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| H37-6 (SW) - H56-20 (RMIL) | Always | Below 1 Ω |
| H37-6 (SW) - Body ground | Always | 1 MΩ or higher |
Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| H37-6 (SW) - Body ground | Ignition switch ON | Below 1 V |
|
| ||||
| OK | |
| 3.INSPECT RSCA OFF SWITCH |
![]() |
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Remove the RSCA OFF switch (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 4 (SW) - 1 (E) | RSCA OFF switch is in on position | Below 1 Ω |
| 4 (SW) - 1 (E) | RSCA OFF switch is in off position | 1 MΩ or higher |
|
| ||||
| OK | |
| 4.CHECK INSTRUMENT PANEL WIRE (CENTER AIRBAG SENSOR - RSCA OFF SWITCH AND BODY GROUND) |
![]() |
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Disconnect the connector from the center airbag sensor and RSCA OFF switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| H56-19 (RMSW) - H46-4 (SW) | Always | Below 1 Ω |
| H46-4 (SW) - Body ground | Always | 1 MΩ or higher |
| H46-1 (E) - Body ground | Always | Below 1 Ω |
Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| H46-4 (SW) - Body ground | Ignition switch ON | Below 1 V |
| H46-1 (E) - Body ground |
|
| ||||
| OK | ||
| ||