Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM

DTC    B1445/45    Passenger Side Cool Air Bypass Damper Control

for Preparation Click here


DESCRIPTION

The cool air bypass damper servo sends pulse signals to inform the air conditioning amplifier of the damper position. The air conditioning amplifier activates the motor (normal, reverse) based on the signals to move the cool air bypass damper servo to any position. As a result, when the air conditioner is operating, the temperature of the air blowing toward the passenger's head area is controlled.

HINT:
  1. Although the Techstream title says "Passenger Side", there is only one cool air bypass servo motor on this vehicle.
  2. Confirm that no mechanical problem is present because this diagnostic trouble code can be output when either a damper link or damper is mechanically locked.


DTC Code
DTC Detection Condition
Trouble Area
B1445/45
Cool air bypass servo motor position sensor value does not change even if air conditioning amplifier operates cool air bypass servo motor
  1. Cool air bypass damper servo
  2. Air conditioning harness
  3. Air conditioning amplifier

WIRING DIAGRAM


E156865E25


INSPECTION PROCEDURE

1.PERFORM ACTIVE TEST USING TECHSTREAM (COOL AIR BYPASS PULSE)
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Body Electrical / Air Conditioner / Active Test / Cool Air Bypass Pulse.

  1. While performing the Active Test, confirm that the air blown from the front center and front side registers changes in temperature.

    Air Conditioner 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Cool Air Bypass Pulse
    Cool air bypass servo motor
    Min.: 0
    Max.: 255
    -

    OK:
    Air temperature changes in response to the operation of the cool air bypass servo motor.


    Result 
    Result
    Proceed to
    NG
    A
    OK (When troubleshooting according to Problem Symptoms Table)
    B
    OK (When troubleshooting according to the DTC output)
    C



B
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

C
REPLACE AIR CONDITIONING AMPLIFIER (Click here)
A


2.REPLACE COOL AIR BYPASS DAMPER SERVO (for Passenger Side)
  1. Temporarily replace the cool air bypass damper servo with a new one (Click here).

    HINT:
    Since the damper servo cannot be inspected while it is removed from the vehicle, replace the damper servo with a new one and check that the condition returns to normal.


NEXT


3.CHECK FOR DTC
  1. Clear the DTC (Click here).

  1. Check for DTC (Click here).

    OK:
    DTC is not output.



NG
Go to step 4
OK

END (COOL AIR BYPASS DAMPER SERVO IS DEFECTIVE) 

4.REPAIR OR REPLACE AIR CONDITIONING HARNESS
  1. Repair or replace the air conditioning harness (Click here).


NEXT


5.CHECK FOR DTC
  1. Clear the DTC (Click here).

  1. Check for DTC again (Click here).

    OK:
    DTC is not output.



NG
REPLACE AIR CONDITIONING AMPLIFIER (Click here)
OK

END