Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › INTUITIVE PARKING ASSIST SYSTEM

INTUITIVE PARKING ASSIST SYSTEM > Indicator Circuit

for Preparation Click here


DESCRIPTION

The sonar ON/OFF indicator light and warning indicator lights are installed in the accessory meter assembly.

WIRING DIAGRAM


E146058E02


INSPECTION PROCEDURE

1.INSPECT FUSE (ECU-IG No. 1)


    E160643E01
  1. Remove the ECU-IG No. 1 fuse from the main body ECU.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    ECU-IG No. 1 fuse
    Always
    Below 1 Ω

  1. Install the fuse.



NG
REPLACE FUSE
OK


2.CHECK HARNESS AND CONNECTOR (ACCESSORY METER ASSEMBLY - BATTERY AND BODY GROUND)


    E146329E03
  1. Disconnect the I22 accessory meter assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    I22-23 (IG) - Body ground
    Ignition switch ON
    11 to 14 V

  1. Reconnect the accessory meter assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (ACCESSORY METER ASSEMBLY - CLEARANCE WARNING ECU)


    E146059E04
  1. Disconnect the H43 clearance warning ECU connector.

  1. Disconnect the I22 accessory meter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H43-15 (L1) - I22-3 (RR)
    Always
    Below 1 Ω
    H43-16 (L2) - I22-4 (FR)
    H43-17 (L3) - I22-7 (RL)
    H43-18 (L4) - I22-8 (FL)
    H43-19 (L5) - I22-5 (BK)
    H43-20 (L6) - I22-6 (OP)
    H43-15 (L1) - Body ground
    Always
    10 kΩ or higher
    H43-16 (L2) - Body ground
    H43-17 (L3) - Body ground
    H43-18 (L4) - Body ground
    H43-19 (L5) - Body ground
    H43-20 (L6) - Body ground

  1. Reconnect the clearance warning ECU connector.

  1. Reconnect the accessory meter assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.REPLACE ACCESSORY METER ASSEMBLY
  1. Replace the accessory meter assembly with a normally functioning or new accessory meter assembly (Click here).

  1. Check that the accessory meter indicator operates normally.

    OK:
    Accessory meter indicator operates normally.



NG
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

END (ACCESSORY METER IS DEFECTIVE)