Home › Drivetrain ยท A750F AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSMISSION SYSTEM

DTC    U0100    Lost Communication with ECM / PCM "A"

for Preparation Click here


DESCRIPTION

The engine control unit and the transmission control unit are located inside the ECM. The engine control unit intercommunicates with the transmission control unit with the Controller Area Network (CAN). If there is a problem in this intercommunication, the ECM sets a DTC.

DTC Code
DTC Detection Condition
Trouble Area
U0100
No communication with ECM continues
ECM

MONITOR STRATEGY


Related DTCs
U0100: Verify communication
Required sensors/Components
ECM
Frequency of operation
Continuous
Duration
1.25 seconds
MIL operation
Immediately
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


The monitor will run whenever the following DTCs are not present
None
Battery voltage
10.5 V or more

TYPICAL MALFUNCTION THRESHOLDS


Communication signal
Lost communication with ECM

INSPECTION PROCEDURE

1.CHECK DTC OUTPUT (IN ADDITION TO DTC P0100)
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Powertrain / ECT / Trouble Codes.

  1. Read the DTCs using the Techstream.
    Result 
    Result
    Proceed to
    Only U0100 is output
    A
    U0100 and other DTCs are output
    B

    HINT:
    If any other codes besides U0100 are output, perform troubleshooting for those DTCs first.



B
GO TO DTC CHART (Click here)
A


2.REPLACE ECM
  1. Replace the ECM (Click here).


NEXT


3.CHECK IF DTC RECURS
  1. Clear the DTC (Click here).

  1. Start the engine.

  1. Read the DTCs using the Techstream.
    Result 
    Result
    Proceed to
    No DTC
    A
    Other DTCs
    B



B
GO TO DTC CHART (Click here)
A

END