FRONT CRANKSHAFT OIL SEAL > INSTALLATION |
| 1. INSTALL TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL |
Apply MP grease to the lip of a new oil seal.
![]() |
Using SST and a hammer, tap in the oil seal to a depth between 0 to 1.0 mm (0 to 0.0394 in.) from the timing chain cover edge.
| 2. INSTALL CRANKSHAFT TIMING GEAR KEY |
![]() |
Install the crankshaft timing gear key.
| 3. INSTALL CRANKSHAFT PULLEY |
Align the pulley set key with the key groove of the pulley, and slide on the pulley.
![]() |
Using SST, install the pulley set bolt.
| 4. INSTALL FRONT STABILIZER BAR |
![]() |
Install the stabilizer bar and 2 stabilizer bushes and 2 stabilizer brackets with the 4 bolts.
| 5. INSTALL RADIATOR ASSEMBLY |
Install the radiator assembly (Click here).
| 6. INSPECT FOR OIL LEAK |
Start the engine. Make sure that there are no oil leaks from the area that was worked on.