Home › Audio/Visual/Telematics › AUDIO / VIDEO › REAR SEAT ENTERTAINMENT SYSTEM

REAR SEAT ENTERTAINMENT SYSTEM > Sound Signal Circuit between Navigation Receiver Assembly and Television Display Assembly

for Preparation Click here


DESCRIPTION

This circuit sends a sound signal from the television display assembly to the navigation receiver assembly.

WIRING DIAGRAM


E145840E04


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY ASSEMBLY - NAVIGATION RECEIVER ASSEMBLY)


    E145843E06
  1. Disconnect the U2 television display assembly connector.

  1. Disconnect the I25 navigation receiver assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I25-2 (CDR+) - U2-28 (R+)
    Always
    Below 1 Ω
    I25-3 (CDR-) - U2-29 (R-)
    I25-4 (CDL+) - U2-30 (L+)
    I25-5 (CDL-) U2-31 (L-)
    I25-1 (CSLD) - U2-27 (SLD9)
    I25-2 (CDR+) - Body ground
    Always
    10 kΩ or higher
    I25-3 (CDR-) - Body ground
    I25-4 (CDL+) - Body ground
    I25-5 (CDL-) Body ground
    I25-1 (CSLD) - Body ground

  1. Reconnect the television display assembly connector.

  1. Reconnect the navigation receiver assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT TELEVISION DISPLAY ASSEMBLY


    E145844E03
  1. Using an oscilloscope, check the waveform between each terminal and the body ground according to the conditions, as shown in the table below.

    OK: Waveform:
    Tester Connection
    Condition
    Specified Condition
    U2-28 (R+) - Body ground
    Audio sound is being produced
    A waveform synchronized with sound is output
    U2-29 (R-) - Body ground
    U2-30 (L+) - Body ground
    U2-31 (L-) - Body ground



NG
REPLACE TELEVISION DISPLAY ASSEMBLY (Click here)
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)