Home › Audio/Visual/Telematics › AUDIO / VIDEO › REAR SEAT ENTERTAINMENT SYSTEM

REAR SEAT ENTERTAINMENT SYSTEM > Display Signal Circuit between Television Display Assembly and Navigation Receiver Assembly

for Preparation Click here


DESCRIPTION

This circuit sends a display signal from the television display assembly to the navigation receiver assembly.

WIRING DIAGRAM


E145839E02


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY ASSEMBLY - NAVIGATION RECEIVER ASSEMBLY)


    E145841E02
  1. Disconnect the U2 television display assembly connector.

  1. Disconnect the I5 navigation receiver assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    U2-11 (NTSC) - I5-1 (VV+)
    Always
    Below 1 Ω
    U2-10 (SGN1) - I5-4 (VV-)
    U2-9 (SLD) - I5-4 (VV-)
    U2-11 (NTSC) - Body ground
    Always
    10 kΩ or higher
    U2-10 (SGN1) - Body ground

  1. Reconnect the television display assembly connector.

  1. Reconnect the navigation receiver assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT TELEVISION DISPLAY ASSEMBLY (NTSC SIGNAL)


    E145842E02
  1. Using an oscilloscope, check the waveform.
    Reference 
    Terminal Connection
    U2-11 (NTSC) - Body ground
    Tester Range
    200 mV/DIV., 10 μs/DIV.
    Vehicle Condition
    DVD displayed on television display

OK:
Waveform is as shown in the illustration.



NG
REPLACE TELEVISION DISPLAY ASSEMBLY (Click here)
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)