REAR UPPER ARM > INSTALLATION |
| 1. TEMPORARILY INSTALL REAR UPPER CONTROL ARM ASSEMBLY LH |
![]() |
Temporarily install the rear upper control arm with the 3 bolts and 3 nuts.
| 2. CONNECT REAR SPEED SENSOR WIRE |
![]() |
Connect the rear speed sensor wire with the 4 bolts.
Connect the speed sensor connector.
| 3. INSTALL REAR BRAKE FLEXIBLE HOSE |
![]() |
Install the rear brake flexible hose with the 3 bolts.
| 4. INSTALL REAR DISC BRAKE CYLINDER ASSEMBLY LH |
![]() |
Apply lithium soap base glycol grease to the sliding part and seal surface of the 2 slide pins.
![]() |
Install the 2 slide pins.
| 5. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH |
![]() |
Install the rear height control sensor with the nut.
Connect the rear height control sensor connector.
![]() |
Align the matchmark on the rear height control sensor link and bracket.
Install the rear height control sensor link with the nut.
| 6. INSTALL REAR WHEEL |
| 7. STABILIZE SUSPENSION |
Lower the vehicle.
Press down on the vehicle several times to stabilize the suspension.
| 8. TIGHTEN REAR UPPER CONTROL ARM ASSEMBLY LH |
Tighten the 3 bolts and 3 nuts.
| 9. INSTALL FUEL TANK ASSEMBLY (for 3UR-FE) |
| 10. INSTALL FUEL TANK ASSEMBLY (for 2UZ-FE) |
| 11. INSPECT AND ADJUST REAR WHEEL ALIGNMENT |