Home › Suspension › REAR SUSPENSION › REAR STABILIZER BAR

REAR STABILIZER BAR > REMOVAL

for Preparation Click here



1. REMOVE EXHAUST PIPE ASSEMBLY TAIL (for 3UR-FE)


A184925
  1. Remove the bolt, clamp and gasket.

  1. Disconnect the tailpipe assembly from the exhaust pipe support.



2. REMOVE EXHAUST PIPE ASSEMBLY TAIL (for 2UZ-FE)


    A166393
  1. Remove the bolt and clamp.

  1. Disconnect the exhaust pipe support and remove the tail exhaust pipe assembly.

  1. Remove the gasket from the center exhaust pipe assembly.



3. REMOVE PROPELLER SHAFT ASSEMBLY (for 2WD)
(Click here)


4. REMOVE PROPELLER SHAFT HEAT INSULATOR (for 4WD)


    C158450
  1. Remove the 2 bolts and propeller shaft heat insulator.



5. REMOVE TRANSFER HEAT INSULATOR (for 4WD)


    C158451
  1. Remove the 3 bolts and transfer heat insulator.



6. REMOVE PROPELLER SHAFT ASSEMBLY (for 4WD)


    C179258E01
  1. Place matchmarks on the propeller shaft flange and differential flange.

  1. Place matchmarks on the propeller shaft flange and transfer flange.

  1. Remove the 8 nuts and then remove the propeller shaft assembly.



7. REMOVE REAR STABILIZER LINK ASSEMBLY LH


C180603
  1. Remove the 2 nuts and the rear stabilizer link.

    HINT:
    If the ball joint turns together with the nut, use a hexagon wrench to hold the stud.



8. REMOVE REAR STABILIZER LINK ASSEMBLY RH

HINT:
Perform the same procedure as for the LH side.



9. REMOVE REAR STABILIZER BRACKET


    C180768E01
  1. Remove the 4 bolts and 2 brackets.



10. REMOVE REAR STABILIZER BAR
  1. Remove the rear stabilizer bar from the vehicle.



11. REMOVE REAR STABILIZER BUSH
  1. Remove the 2 bushes from the rear stabilizer bar.