Home › Power Source / Network · NETWORKING › LIN COMMUNICATION SYSTEM

DTC    B1287    Back Door ECU Communication Stop

for Preparation Click here


DESCRIPTION

This DTC is stored when LIN communication between the back door ECU and main body ECU stops for 10 seconds or more.

DTC Code
DTC Detection Condition
Trouble Area
B1287
No communication between the back door ECU and main body ECU for 10 seconds or more.
  1. Back door ECU
  2. Main body ECU
  3. Harness or connector

WIRING DIAGRAM


E160675E02


INSPECTION PROCEDURE

NOTICE:
When using the Techstream with the ignition switch off to troubleshoot:
Connect the Techstream to the vehicle, and turn a courtesy switch on and off at 1.5 second intervals until communication between the Techstream and vehicle begins.

HINT:
DTC B2325 is stored when the communication between the back door ECU and main body ECU stops.

1.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - BACK DOOR ECU)


    E160676E01
  1. Disconnect the H2 main body ECU connector.

  1. Disconnect the V2 back door ECU connector.

  1. Measure the resistance and voltage according to the value(s) in the tables below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H2-10(LIN2) - V2-16(MPX1)
    Always
    Below 1 Ω
    H2-10(LIN2) or V2-16(MPX1) - Body ground
    Always
    10 kΩ or higher

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    V2-16(MPX1) - Body ground
    Always
    Below 1 V

  1. Reconnect the main body ECU connector.

  1. Reconnect the back door ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK BACK DOOR ECU (BACK DOOR ECU - BATTERY AND BODY GROUND)


    E160677E02
  1. Disconnect the V2 back door ECU connector.

  1. Measure the resistance and voltage according to the value(s) in the tables below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    V2-6(GND) - Body ground
    Always
    Below 1 Ω

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    V2-1(BDR) - Body ground
    Always
    11 to 14 V
    V2-7(BECU) - Body ground

  1. Reconnect the back door ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.REPLACE BACK DOOR ECU
  1. Temporarily replace the back door ECU with a new or normally functioning one (Click here).

  1. Clear the DTC (Click here).


NEXT


4.CHECK FOR DTC
  1. Recheck for DTCs (Click here).
    Result 
    Result
    Proceed to
    DTC B1206 is not output
    A
    DTC B1206 is output
    B



B
REPLACE MAIN BODY ECU
A

END (BACK DOOR ECU IS DEFECTIVE)