REAR DOOR > ADJUSTMENT |
![]() |
| 1. INSPECT REAR DOOR |
Check that the clearance measurements are within the standard ranges.

| Area | Measurement | Area | Measurement |
| A | 4.0 to 7.0 mm (0.157 to 0.276 in.) | G | 8.0 to 12.0 mm (0.315 to 0.472 in.) |
| B | -1.5 to 1.5 mm (-0.059 to 0.059 in.) | H | 1.6 to 4.6 mm (0.063 to 0.181 in.) |
| C | 4.0 to 7.0 mm (0.157 to 0.276 in.) | I | 7.8 to 10.8 mm (0.307 to 0.425 in.) |
| D | 0.6 to 3.6 mm (0.024 to 0.142 in.) | J | -1.5 to 1.5 mm (-0.059 to 0.059 in.) |
| E | 4.0 to 7.0 mm (0.157 to 0.276 in.) | K | 5.0 to 8.0 mm (0.197 to 0.315 in.) |
| F | -1.5 to 1.5 mm (-0.059 to 0.059 in.) | - | - |
| 2. ADJUST REAR DOOR |
Disconnect the cable from the negative battery terminal.
![]() |
Using SST, adjust the door horizontally and vertically by loosening the body side hinge bolts.
Tighten the body side hinge bolts after the adjustment.
![]() |
Using SST, adjust the door horizontally and vertically by loosening the door side hinge bolts.
Tighten the door side hinge bolts after the adjustment.
![]() |
Using "TORX" socket wrench T40, adjust the striker position by slightly loosening the striker mounting screws and hitting the striker with a plastic-faced hammer.
Using "TORX" socket wrench T40, tighten the striker mounting screws after the adjustment.
Connect the cable to the negative battery terminal.
Inspect the SRS warning light (Click here).