Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT AIRBAG SENSOR

FRONT AIRBAG SENSOR > REMOVAL

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).

HINT:
The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE FRONT AIRBAG SENSOR


    C180940E01
  1. Disconnect the airbag connector.

    NOTICE:
    1. Do not disconnect the airbag connector by pulling the wire harness.
    2. Release the lock without holding the upper side of CPA.


    1. While pushing the housing, slide only the CPA backward (from its provisionally locked state).

    2. Detach the connector while pushing the housing in the provisionally locked state.



    3. B106583
    4. After detaching the connector, confirm that the CPA protrudes beyond the rear of the housing.



    C180938
  1. Remove the bolt.

  1. Disengage the guide and remove the front airbag sensor.

    CAUTION:
    Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.