FUEL TANK > INSTALLATION |
| 1. INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY |
Apply a light coat of gasoline or grease to a new gasket, and install it to the fuel tank.
![]() |
Align the protrusion of the pump and gauge tube with the groove of the fuel tank.
Install the fuel suction with pump and gauge tube into the fuel tank.
Put the retainer on the fuel tank. While holding the fuel suction with pump and gauge tube, tighten the retainer one complete turn by hand.
![]() |
Set SST on the retainer.
![]() |
Using SST, tighten the retainer until the mark on the retainer is within range A on the fuel tank, as shown in the illustration.
![]() |
Install the 2 fuel tank tubes with the 2 tube joint clips.
![]() |
| 2. INSTALL NO. 1 FUEL TANK HEAT INSULATOR |
![]() |
Install the No. 1 fuel tank heat insulator with the 4 clips and nut.
| 3. INSTALL FUEL TANK ASSEMBLY |
Set the fuel tank on a transmission jack and raise the fuel tank assembly.
![]() |
Connect the wire harness clamp and fuel pump connector to the fuel tank assembly.
Raise the transmission jack.
![]() |
Install the 2 fuel tank bands with the 2 pins and 2 clips.
Connect the 2 fuel tank bands with the 2 bolts.
![]() |
Connect the fuel tank breather tube to the fuel tank inlet pipe sub-assembly.
![]() |
Connect the vent line hose and install the retainer.
![]() |
Connect the fuel tank to filler pipe hose to the fuel tank assembly.
| 4. CONNECT FUEL TANK RETURN TUBE |
![]() |
Connect the fuel tank return tube.
Attach the lock claws to the connector by pushing down on the cover, as shown in the illustration.
| 5. CONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY |
![]() |
Connect the fuel tank main tube.
Attach the lock claws to the connector by pushing down on the cover, as shown in the illustration.
| 6. INSTALL FUEL TANK CAP |
| 7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 8. INSPECT FOR FUEL LEAK |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON and Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.
Check that there are no fuel leaks after doing maintenance anywhere on the fuel system.