Home › Steering › STEERING COLUMN › POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM

DTC    B2624    Vehicles Speed Malfunction

for Preparation Click here


DESCRIPTION

The multiplex tilt and telescopic ECU forms a network with the ECUs of other systems through the communication bus. Each ECU informs the other ECUs that they are connected to the network by outputting a specified signal (periodic signal) to the communication bus at regular intervals. The multiplex tilt and telescopic ECU receives vehicle speed signals from the combination meter via the communication bus to prevent improper operation of the auto away/return function during driving.

DTC Code
Detection Condition
Trouble Area
B2624
When either condition below is met:
  1. The auto away function is disabled with the last vehicle speed signal* of 10 km/h (6 mph) or more.
  2. Vehicle speed signal is lost for 5 seconds or more and the auto away/return function is disabled.
  1. CAN communication system
  2. Combination meter
  3. Multiplex tilt and telescopic ECU

HINT:
*: If the ignition switch is turned off immediately after the vehicle comes to a sudden stop, the last vehicle speed signal may not be 0 km/h (0 mph).


INSPECTION PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check the DTC of the CAN communication system (Click here).
    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2.READ VALUE USING TECHSTREAM (SPEED SIGNAL)
  1. Use the Data List to check if the speed signal is functioning properly.

    Tilt & Telescopic 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Freez Speed Info
    Vehicle speed data / min.: 0 km/h (0 mph), max.: 255 km/h (158 mph)
    Actual vehicle speed
    -

Result 
Result
Proceed to
OK or NG (Tester indication is abnormal)
A
NG (Meter indication is abnormal)
B

HINT:
Vehicle speed of 3 km/h (2 mph) or more may be displayed on the Techstream screen immediately after the vehicle comes to a sudden stop. This is caused by a delay in vehicle signal input via the communication bus and is not a malfunction.



B
CHECK COMBINATION METER SYSTEM (Click here)
A

REPLACE MULTIPLEX TILT AND TELESCOPIC ECU (Click here)